Flush the toilet and then remove the flapper valve.
Toilet water shut off valve leaking australia.
The small plastic tub will catch the water from the pipes to avoid spillage.
Disassemble the shutoff valve.
Flush all the toilets in the home.
Open all the cold water faucets start with the highest faucet 2nd or 3rd floor and work to your lowest faucet first or basement floor.
Water will stop flowing into the tank.
Do not remove the valve just tighten the packing nut.
Wrap the slip joint pliers jaws in masking tape to protect your shut off valve from any scratches caused by the sharp edges.
Next shut off the main water supply to the toilet and detach and drain the pipes using a wrench or pliers.
If the street side valve needs replacement as well you ll have to call your water utility company to shut off the water supply at the curb.
Then follow our step by step instructions on our article.
If you still can t stop the dripping you ll have to turn off the main valve and replace the drippy one completely.
To fix a leaking flapper valve turn the water shut off valve on the intake pipe just below the toilet tank to the closed position.
Shut off water supply to the house at the main.
Wrap cloth or masking tape on the plier s jaws to protect the nut s finish.
How to replace a toilet seal in 16 steps.
Hopefully this is enough to compress the rubber gasket so that it is sealed on the valve stem to prevent water leaks.
Tighten the packing nut on the toilet shutoff valve one eighth turn clockwise to try to seal a leak around the nut.
When you re ready to get started shut off the water.
You can do this by turning the valve by the toilet base clockwise.
Use light steady pressure so you don t damage the water lines.
If the main valve is the one that s dripping you ll need to turn off the street side valve before replacing it.
Wait approximately 20 to 30 minutes.
Then flush the toilet to empty the tank.
Let water drain from open faucets.
It is located inside the toilet tank at the bottom.
Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work.
Water leak shut off valve fixing for a leaky toilet water shut off valve the easiest solution is to tighten the package nut 1 4 turn with a wrench.
Place the small container underneath the valve in case some water leaks into it while you do the repairs.
The chain hook must be removed and a new flapper set into its place.
