Sunsetter Awning Remote Flashes Red Light

If not replace the cr2430 battery.

Sunsetter awning remote flashes red light.

Manual motor control bar. If it does continue to the next step. Sunsetter recommends channel 1 be used to operate your awning and channel 2 be used to operate your led light system unless you did not purchase a motorized awning then use channel 1 to operate your led light system. Electric drill use gloves and eye protection center punch hammer pencil tape measure.

If not replace the cr2430 battery. Verify that the red led light on the remote transmitter comes on when you press and hold one of the buttons marked with an up arrow a down arrow or the word my if the red light does not come on at all or blinks for less than five seconds you will need to replace the battery with a new battery 3v lithium cr2430. The awnings are operated with buttons on the motor control or by a remote control. Press and hold my for 8 seconds the light should blink the entire time.

Verify that the red light on the remote transmitter comes on when you press and hold the button. The multi channel remote transmitter must be programmed to the light control box the first time the led light system is plugged in. Press the neutral middle button on the transmitter.