Lifting beam vs spreader beam a sling alone isn t always enough to safely move a load.
Spreader beam vs lifting beam.
A spreader beam utilises a two legged top sling.
About spreader beams and lifting beams a lifting beam has a centre lifting lug at the top that connects to a crane hook.
At the outset it is important to clarify the difference between a spreader and a lifting beam.
If we resolve the forces on the whole beam we get the force diagram as above.
While both a lifting beam and a spreader bar is similar in that they create a connection point between the load and crane there are differences that make one better than the other in specific instances.
Spreader beams have lugs at either end which attach to the crane s sling and two lugs on their underside that attach to the load.
Beams increase the safety and efficiency.
Lifting beams on the other hand consist of a long beam that converts the lifting load into a bending moment through the beam.
On the other hand lifting beams consist a long beam that serves the lifting load into a bending moment through the beam.
The way their lugs are orientated means the load taken by the spreader beam is mainly compressive so they can carry a great deal of weight compared to their size.
This is when riggers turn to below the hook lifting devices like lifting beams and spreader beams.
Arrangement of a spreader bar spreader beam vs lifting beam.
Under the beam are two or more slugs attached to and support the load via hook or sling.
Shop grainger today for spreader beams and other lifting equipment that can help you lift large items safely.
It is a simple design with one lifting eye on the beam s topside for connecting the crane.
As a result a spreader beam will likely fail if it is not used correctly remember it is 3 to 4 times smaller than a lifting beam.
A spreader beam is designed to take primarily compressive loads as can be seen in the figure above.
Lifting beams have a single centred lifting point on the top side of the beam to connect to a crane hoist or other lifting mechanism.
The main difference between a lifting beam and a spreader bar is the design which dictates the way the force is transmitted during the lift.
Find the load capacity minimum and maximum spread and headroom that fits your application.
The beam was designed to deal with compression not bending.
When headroom is limited use a lifting beam.
Heavy or unbalanced lifts sometimes require more stability or capacity than a sling hitch can give.
Lifting beams and spreader bars are some of the most common types of lifting devices however the difference is often misunderstood.
